Servicing The Fuses - Toro 74410 Operator's Manual

With a 48in or 52in 7-gauge side discharge mower

Hide thumbs Also See for 74410:

Operator's manual (52 pages)

Table Of Contents

Table of Contents

6. Remove both wing nuts (1/4 inch) securing the

battery clamp (Figure 39).

7. Remove the battery.

Installing the Battery

1. Position battery in the tray with the terminal posts

toward the engine (Figure 39).

2. First, install the positive (red) battery cable to

positive (+) battery terminal.

3. Then install the negative battery cable and ground

wire to the negative (-) battery terminal.

4. Secure the cables with 2 bolts (1/4 x 3/4 inch),

2 washers (1/4 inch), and 2 locknuts (1/4 inch)

(Figure 39).

5. Slide the red terminal boot onto the positive (red)

battery post.

6. Secure battery with J-bolts, hold down clamp and

2 washers (1/4 inch), and 2 wing nuts (1/4 inch)

(Figure 39).

Charging the Battery

Charging the battery produces gasses that can

explode.

Never smoke near the battery and keep sparks

and flames away from battery.

Important: Always keep the battery fully charged

(1.265 specific gravity). This is especially important

to prevent battery damage when the temperature is

below 32°F (0°C).

1. Charge battery for 10 to 15 minutes at 25 to 30 amps

or 30 minutes at 4-6 amps.

2. When the battery is fully charged, unplug the charger

from the electrical outlet, then disconnect the

charger leads from the battery posts (Figure 40).

1. Positive Battery Post

2. Negative Battery Post

3. Install the battery in the machine and connect the

battery cables; refer to Installing the Battery.

Note: Do not run the machine with the battery

disconnected, electrical damage may occur.