Operating The Parking Brake; Starting And Stopping The Engine - Toro 74410 Operator's Manual

Figure 10
1. Safe Zone-use the
Z Master here on slopes
less than 15 degrees or
flat areas.
2. Use walk behind mower
and/or hand trimmer near
drop-offs and water.
This machine produces sound levels in excess
of 85 dBA at the operators ear and can cause
hearing loss through extended periods of
exposure.
Wear hearing protection when operating this
machine.
Use protective equipment for your eyes, ears, feet, and
head.
Figure 11
1. Warning— wear hearing protection

Operating the Parking Brake

Always set the parking brake when you stop the
machine or leave it unattended.
3. Water
Setting the Parking Brake
1. Move the motion control levers (Figure 18) out to
the neutral lock position.
2. Pull up and back on the parking brake lever to set
the parking brake (Figure 12). The parking brake
lever should stay firmly in the engaged position.
Parking brake may not hold machine parked
on a slope and could cause personal injury or
property damage.
Do not park on slopes unless wheels are
chocked or blocked
Releasing the Parking Brake
Push forward and down on the parking brake lever to
release the parking brake (Figure 12).
1. Parking brake-ON
2. Parking brake-OFF
Starting and Stopping the
Engine
Starting the Engine
1. Sit on the seat and move the motion controls to
neutral locked position.
2. Set the parking brake; refer to Setting the Parking
Brake.
3. Move the PTO (power take off) switch to the Off
position (Figure 13).
15
Figure 12
3. Brake Stop