Think Safety First - Toro 74410 Operator's Manual

5. To raise the roll bar, remove the hairpin cotter pins
and remove the two pins (Figure 8).
6. Raise the roll bar to the upright position and install
the two pins and secure them with the hairpin cotter
pins (Figure 8).
Important: Always use the seat belt with the
roll bar in the raised position.
1. Roll bar
2. Raised position
Important: Tighten the front knobs against
the center roll bar ends (Figure 9).
1. Front handle
Figure 8
3. Pin
4. Hairpin cotter pin
Figure 9

Think Safety First

Please read all safety instructions and symbols in the
safety section. Knowing this information could help
you or bystanders avoid injury.
Operating on wet grass or steep slopes can
cause sliding and loss of control.
Wheels dropping over edges can cause rollovers,
which may result in serious injury, death or
drowning.
There is no rollover protection when the roll
bar is down.
Always keep the roll bar in the raised and locked
position and use the seat belt.
Read and follow the rollover protection
instructions and warnings.
To avoid loss of control and possibility of
rollover:
• Do not operate near drop-offs or near water.
• Do not operate on slopes greater than
15 degrees.
• Reduce speed and use extreme caution on
slopes.
• Avoid sudden turns or rapid speed changes.
14