Installing The Roll Over Protection System - Toro 74450TE Setup Instructions

3. Remove the wheel nuts from both sides of the
vehicle and remove the right angle retaining plate.
Discard the screws and retaining plate.
4. Mount the wheels with the valve stem to the outside
and secure them with the wheel nuts previously
removed.
5. Torque the wheel nuts to 95 ft-lb (128 N-m).
6. Remove the jack-stands.
Figure 4
Figure 5
4
Installing the Roll Over
Protection System
Parts needed for this procedure:
1 Roll bar, right section
1 Roll bar, left section
1 Roll bar, center section
8 Bolt, (3/8 x 1 inch)
8 Curved washer
8 Flange nut, (3/8 inch)
2 Bolt, (1/2 x 3–1/4 inch)
2 Flange nut, (1/2 inch)
Procedure
1. Loosely install the right and left roll bar section to
the frame, with 8 bolts (3/8 x 1 inch), 8 curved
washers, and 8 flange nuts (3/8 inch).
Note: The curve washer cone must be installed
toward the bolt head.
3
Figure 6