Toro 31598N Operator's Manual page 22

Figure 15
1. Screen 1
2. Screen 2
3. Audible alarm
Operator Information
There are two screens that will monitor and display the
machine functions that the operator can use.
Screen 1 will display:
Top Left Gauge-Engine Coolant Temperature
Top Right Gauge-Fuel Level
Left to Right on the Bottom Half
1. PTO Engaged
2. Parking Brake Engaged
3. Fan Reversing
4. Cruise Control Engaged
5. H/L (Hi/Low speed range)
Bottom Left Corner-Air Intake Heater Active
Bottom Middle-Traction Assist Engaged
Bottom Right-Machine Hours
Screen 2 will display:
Top Left Corner-Engine RPM
Top Right Corner-Hydraulic Oil Temperature
Lower Left Corner-Battery Voltage
Lower Right Corner-Service Due
4. Fault screen
5. Exit
Engine Coolant Temperature Indicator
This display indicates the engine coolant temperature
16).
Parking Brake Indicator
This display indicates that the parking brake is actuated
(Figure 16).
PTO Indicator
This display indicates (Figure
Fan Reverse Indicator
This display indicates (Figure
in reverse. The fan speed will be controlled by the hydraulic
oil temperature, air intake temperature or engine coolant
temperature and will automatically reverse. A reverse cycle is
automatically initiated, to help blow debris off of the rear
hood screen, when either the engine coolant temperature or
hydraulic oil temperature a certain point.
Cruise Control Indicator
This display indicates (Figure
in operation.
Fuel Level Indicator
This display indicates the level of fuel in the tank
1. Engine coolant
temperature indicator
2. Fuel indicator
3. PTO indicator
4. Air intake heater indicator
5. Parking brake indicator
22
16) when the PTO in engaged.
16) when the fan is operating
16) when the cruise control is
(Figure
Figure 16
6. Fan reverse indicator
7. Traction assist indicator
8. Cruise control indicator
9. Machine hours indicator
10. H / L (Hi / Low) speed
range indicator
(Figure
16).