Toro 31598N Operator's Manual page 16

3). Leave the eccentrics positioned between the deck
mounts.
3. Lower the winglet to the operating position.
Figure 3
1. Winglet
2. Hinge pin
3. Stop bolt
4. Install the front and rear stop bolts through the upper
mounting holes and eccentrics. Make sure the stop bolt
engages the tab on the hinge pin.
5. Install the nuts securing the stop bolts but do not
tighten at this time.
6. Repeat the procedure on left winglet.
4. Eccentric
5. Upper hole
6. Deck mounts
1. Winglet
2. Hinge pin
3. Bolt
7. Install the winglet belts as follows:
•
Start the belt around the winglet spindle pulley and
the front deck spindle pulley
•
Using a ratchet wrench or similar tool, move the
idler pulley away from the pulleys
•
Route the belt around the winglet spindle pulley
and the upper spindle pulley on the front deck.
•
Release the idler pulley to put tension on the belt.
1. Winglet spindle pulley
2. Front deck spindle pulley
8. Install the winglet deck cover and secure with rubber
latch (Figure 6).
16
Figure 4
4. Eccentric
5. Lower hole
(Figure 5).
(Figure
Figure 5
3. Idler pulley assembly
5).