Automation
Viewing the Automation Mode
The Automation mode setting of each channel can be viewed as follows.
Press and hold a channel's [AUTO] button.
1
The channel's Automation mode is displayed on the corresponding channel strip display
while the [AUTO] button is pressed.
Pro Tools
Auto write
Auto touch
Auto latch
Auto read
Auto off
The Automation mode settings of all channels can be viewed as follows.
Press and hold the AUTOMIX [DISPLAY] (AUTO STATUS) button.
2
The Automation modes of all channels are displayed on the channel strip displays while the
AUTOMIX [DISPLAY] (AUTO STATUS) button is pressed.
Setting the Automation Mode
The Automation mode can be set as follows.
While holding down a channel's [AUTO] button, press the AUTOMIX
1
[WRITE], [TOUCH], [LATCH], [TRIM], [READ], or [OFF] button.
The channel's Automation mode is displayed on the corresponding channel strip display
while the [AUTO] button is pressed.
Grouped channels are set together. You can temporarily disable a group in order to set indi-
vidual channels by pressing and holding the USER DEFINED KEYS [12] (CTRL/CLUTCH)
button.
The following shortcuts apply.
To do this...
Set the Automation mode of all channels
Set the Automation mode of all selected
channels
Channel Strip Displays
Wrt
Tch
Ltch
Read
Off
Do this!
USER DEFINED KEYS [5]+AUTOMIX [WRITE], [TOUCH],
[LATCH], [TRIM], [READ], or [OFF]
USER DEFINED KEYS [5]+USER DEFINED KEYS [4]+AUTO-
MIX [WRITE], [TOUCH], [LATCH], [TRIM], [READ], or [OFF]
Automation
[AUTO] Button Indicators
Flashing red (Record Ready)
Red (Recording)
Green
Off
DM2000—Owner's Manual
215