Resetting Faders, Sends, Panpots & Plug-Ins; Navigating The Edit Window - Yamaha DM 2000 Owner's Manual

212
Chapter 19—Pro Tools Remote Layer
Resetting Faders, Sends, Panpots & Plug-ins
Faders, panpots, sends, and plug-ins can be reset to their default values as follows. For faders
and send controls, this is "0." For panpots, it's center.
Make sure that the ENCODER MODE [ASSIGN 4] (INSERT) button indicator is off before
proceeding with these shortcuts.
To do this...
Reset a channel fader
Reset all channel faders
Reset all selected channel faders
Reset a channel panpot
Reset all channel panpots
Reset all selected channel panpots
Reset a channel send level
Reset all channel send levels
Reset all selected channel send levels
Reset the currently selected plug-in
While the [MATRIX 1] (DEFAULT) button is being pressed, its indicator flashes and
"DFLT" appears in the SELECT ASSIGN section of the display.
Grouped channels are reset together. You can temporarily disable a group by pressing and
holding the USER DEFINED KEYS [12] (CTRL/CLUTCH) button before pressing the
[MATRIX 1] (DEFAULT) button.

Navigating the Edit Window

The cursor buttons can be used to navigate the Edit window as follows.
Use the [INC] (CURSOR MODE) button to select Navigation cursor mode.
1
The CURSOR MODE section of the display shows "NAVIGATION."
To move the edit cursor to the previous region boundary, or to the previous
2
marker, press the Left cursor button.
3 To move the edit cursor to the next region boundary, or to the next marker,
press the Right cursor button.
4 To select the track above, press the Up cursor button.
To select the track below, press the Down cursor button.
5
The following shortcuts apply.
To do this...
Extend the selection
Select the previous region
Select the next region
Display the in point of the selected region
in the center of the Edit window
Display the out point of the selected
region in the center of the Edit window
DM2000—Owner's Manual
Do this!
[MATRIX 1]+[SEL]
USER DEFINED KEYS [5]+[MATRIX 1]+[SEL]
USER DEFINED KEYS [5]+USER DEFINED KEYS
[4]+[MATRIX 1]+[SEL]
[PAN], [MATRIX 1]+[ENCODER push]
[PAN], USER DEFINED KEYS [5]+[MATRIX 1]+[ENCODER push]
[PAN], USER DEFINED KEYS [5]+USER DEFINED KEYS
[4]+[MATRIX 1]+[ENCODER push]
AUX SELECT [AUX1–5], [MATRIX 1]+[ENCODER push]
AUX SELECT [AUX1–5], USER DEFINED KEYS
[5]+[MATRIX 1]+[ENCODER push]
AUX SELECT [AUX1–5], USER DEFINED KEYS [5]+USER
DEFINED KEYS [4]+[MATRIX 1]+[ENCODER push]
[MATRIX 1]+EFFECTS PLUG-INS [6]
Do this!
USER DEFINED KEYS [4]+Left or Right cursor button
USER DEFINED KEYS [12]+Left cursor button
USER DEFINED KEYS [12]+Right cursor button
USER DEFINED KEYS [5]+Left cursor button (or LOCATE
MEMORY [IN] button)
USER DEFINED KEYS [5]+Right cursor button (or LOCATE
MEMORY [OUT] button)