6G-10 CRANKING SYSTEM
1. Over-running clutch
2. Pinion stop ring
3. Snap ring
4. Gear shaft
REASSEMBLY
CAUTION:
_ Washing, adjusting and disassembling of shock absorber
_ New oilless bearing have been lubricated when they are
1) Inspect component parts (Refer to page 6G-12) and replace
2) Apply grease (Refer to page 6G-3).
3) Install armature to yoke.
4) Install brushes and brush springs to brush holder.
5) Install brush holder to armature while pushing 4 brushes out-
1. Brush
2. Brush spring
3. Brush holder
6) Install rear bush and then rear bracket cap.
7) Install rear bracket.
8) Tighten brush holder screws.
1. Rear bracket
2. Brush holder screws
9) Install over-running clutch assembly to gear shaft, using care
10) Insert shaft ass'y into front housing with lever positioned as
1. Shaft ass'y
2. Lever
(clutch plate) are not allowed.
supplied as spare parts. DO NOT wash with grease dis-
solving solvent nor lubricate them with other lubricant.
with new ones as necessary.
ward.
for installing direction of pinion stop ring.
shown left figure.