Cylinder Head Cover - Suzuki 2000 Grand Vitara SQ625 Service Manual

6A1-12 ENGINE MECHANICAL (G16 ENGINE)

CYLINDER HEAD COVER

REMOVAL
1) Disconnect negative cable at battery.
2) Remove ignition coil assemblies with high-tension cord.
3) Disconnect PCV valve and breather hose from head cover.
4) Detach accelerator cable from clamp.
5) Remove cylinder head cover with cylinder head cover gasket
and O-rings.
1. Cylinder head
cover
2. Cylinder head
cover gasket
3. O-rings
INSTALLATION
1) Install O-rings and cylinder head cover gasket to cylinder head
cover.
NOTE:
Be sure to check each of these parts for deterioration or any
damage before installation and replace if found defective.
1 Cylinder head
cover gasket
2. O-rings
3. Cylinder head
cover
2) Install cylinder head cover to cylinder head and tighten cover
bolts to specified torque.
Tightening Torque
(a): 11 N
NOTE:
When installing cylinder head cover, use care so that cylin-
der head cover gasket or O-rings will not get out of place or
fall off.
3) Fix accelerator cable with clamp.
4) Install ignition coil assemblies with high-tension cord.
5) Connect PCV valve and breather hose to head cover.
6) Connect negative cable at battery.
.
m (1.1 kg-m, 8.0 lb-ft)