Blomberg KWD 1330 X Manual page 46

for 2 seconds and the warning will be
reactivated.
Caution:
Water filter is for cleaning some
foreign particles in the water. It does not purify
water from microorganisms.
Caution:
Ice off button must always be
pressed during replacement of the water filter
or installing the bypass cover.
Water Reservoir
If you wish to disassemble the water reservoir
from the refrigerator for cleaning the vicinity
of the water reservoir follow the instructions
below;
• Remove the 2 screws by using a cross
headed screwdriver as shown in the figure.
• Gently hold and remove the water reservoir
as shown in the figure.
Caution:
Never remove the bolts, assembled to the
water reservoir.
Ice/Water Dispenser Prior to First Use
• Water mains pressure must not be below 1
bar.
• Water mains pressure must not be over 8
bars.
• Pumps must be used in case the water
mains pressure drops below 1 bar.
• Water system of the refrigerator must be
connected to the cold water line. It must not
be connected to hot water line.
• Do not forget to remove the ice channel
cover from its location before using Ice
Dispenser.
• In case you see condensation on the
dispenser (water drops) or in case you connect
your device to the water mains, make sure
that the anti-condensation switch is pressed.
(See Page 15) Anti-Condensation button is
pressed as a factory setting.
• Dispenser will not work when the door of the
freezer compartment is open. Make sure that
the door is closed for the operation of the
dispenser.
• No water may be obtained in the initial
operation of the refrigerator. This is caused
by the air in the system. To discharge air from
the system, press Dispenser latch for periods
EN
13
REMOVE
Water Reservoir