Block %2: Notice: Tool Travels Directly To Machining; Block %2: Check Number Of Empirical Value Memory; Block %2: Notice! Search Run, Test Run Or Simulation Active; Block %2: Safety Margin Exceeded/Block %2: Allowance - Siemens Sinamics S120 Diagnostic Manual

62202 [Channel %1: ] Block %2: NOTICE: tool travels directly to machining!
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: After block search a position is to be reached by direct approach.
Alarm triggered by following cycle: F_TFS.
Remedy: Check whether the desired position can be reached without collision.
Then execute an NC start.
62300 [Channel %1: ] Block %2: Check number of empirical value memory
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: --
Reaction: Alarm display.
Remedy: Check setpoint value
Program Clear alarm with the Delete key or NC START.
Continuation:
62301 [Channel %1: ] Block %2: Notice! Search run, test run or simulation active
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: - Deactivate program test or test run
62303 [Channel %1: ] Block %2: Safety margin exceeded
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: - Check setpoint value and parameter _TSA
62304 [Channel %1: ] Block %2: Allowance
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm is triggerd by the following cycles: CYCLE974, CYCLE977, CYCLE978, CYCLE979, CYCLE994.
Reaction: Alarm display.
Remedy: The difference between actual and setpoint value is larger than upper tolerance limit (parameter _TUL).
Program Clear alarm with the Delete key or NC START.
Continuation:
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
495