Maintenance; Carrying Tool; Adjusting The Cutting Angle - Makita LS1030N Instruction Manual

1. Stopper pin

MAINTENANCE

1
1. Hex bolt
18

Carrying tool

001792
Make sure that the tool is unplugged. Secure the turn base at
right miter angle fully by means of the grip. Lower the handle
fully and lock it in the lowered position by pushing in the stop-
1
per pin.
Carry the tool by carrying grip as shown in the figure. If you
001774
remove the holders, dust bag, etc., you can carry the tool
more easily.
CAUTION:
• Always secure all moving portions before carrying the
tool.
• Stopper pin is for carrying and storage purposes only
and not for any cutting operations.
CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspection or
maintenance.
WARNING:
• Always be sure that the blade is sharp and clean for the
best and safest performance.

Adjusting the cutting angle

This tool is carefully adjusted and aligned at the factory, but
001781
rough handling may have affected the alignment. If your tool
is not aligned properly, perform the following:
Loosen the grip which secures the turn base. Turn the
turn base so that the pointer points to 0° on the miter
scale. Tighten the grip and loosen the hex bolts securing
the guide fence using the socket wrench.