Measuring - Makita LS1030N Instruction Manual

52∞ 45∞
38∞ 45∞
1 2
1. 52/38° type crown molding
2. 45° type crown molding
3. 45° type cove molding
(1) (2) (3) (4)
1 2
Fig.A
1. Inside corner
2. Outside corner
1
(2)
(1)
(4)
(2)
(3)
(1)
(2)
(1)
1. Inside corner
2. Outside corner
1. Press cutting
001788
Secure the workpiece with the vise. Switch on the tool
without the blade making any contact and wait until the
blade attains full speed before lowering. Then gently
lower the handle to the fully lowered position to cut the
workpiece. When the cut is completed, switch off the tool
and WAIT UNTIL THE BLADE HAS COME TO A COM-
PLETE STOP before returning the blade to its fully ele-
vated position.
2. Miter cutting
Refer to the previously covered "Adjusting the miter
angle".
3. Cutting crown and cove moldings
There are two common types of crown moldings and one
001555
type of cove moldings; 52/38° wall angle crown molding,
45° wall angle crown molding and 45° wall angle cove
molding. See illustrations.
45∞
45∞
3
There are crown and cove molding joints which are
001556
made to fit "Inside" 90° corners ((1) and (2) in Fig. A) and
"Outside" 90° corners ((3) and (4) in Fig. A).

Measuring

Measure the wall length and adjust workpiece on table to
cut wall contact edge to desired length. Always make
sure that cut workpiece length at the back of the work-
piece is the same as wall length. Adjust cut length for
angle of cut. Always use several pieces for test cuts to
check the saw angles.
001557
(1)
(2)
2
(1)
(2)
15