Wiring; Cat5 Or Cat6 Cable - Cisco 5010 User Manual

Wiring

Figure 2-12
1
2
3
4
Wiring

Cat5 or Cat6 Cable

Connect a Cat5 or Cat 6 cable to the RJ-45 network port. The 8-pin connector includes video and PoE
for the camera. PoE (IEEE 802.3af Class 3) injects power over the same cabling that carries the network
data, eliminating the need for a separate power supply. This simplifies the installation and operation of
the camera without affecting network performance.
Note •
•
Cisco Video Surveillance 5010/5011 Indoor Fixed HD IP Dome Camera User Guide
2-10
Attaching the 2.5 mm Monaural Headphone Plug
8 7
2.5 mm Stereo Plug
Plug Shoulder Pin
Center Conductor
Support Sleeve
The camera will autosense and configure itself to use either a crossover cable or a straight cable.
A CAT5 is sufficient for 100 MHz transmission. Use a CAT6 cable for both 100 and 1000 MHz
transmission.
1 2 3
6 5 4
5 Shrink Fit Tubing
6 Coaxial Cable
7 Coaxial Braid Shield
8
Crimp Pin Arm
Chapter 2 Installation
OL-22669-01