Cisco 5010 User Manual page 15

Chapter 2 Installation
Position the camera:
Step 6
View the camera image using the service jack or a Web browser.
a.
Unlock the tab locks located on each side of the camera.
b.
Manually rotate and tilt the camera module to position the camera. Do not over-rotate the module.
c.
Lock the tab locks to secure the camera.
d.
Figure 2-3
1 Pan 368°
2 Tab lock
Focus the lens:
Step 7
a. View the camera image using the service jack or a Web browser.
b. Press the auto back focus button once to center the focus mechanism. The button is located on the
rim of the back box.
c. Manually adjust the zoom and focus of the lens to the desired field of view (refer to the instructions
shipped with the lens).
Press and hold the back focus button for three seconds to start the auto back focus mechanism.
d.
Step 8 Install the dome liner and lower dome (refer to
page 2-7).
OL-22669-01
Positioning the Camera
1
2
3
4
Cisco Video Surveillance 5010/5011 Indoor Fixed HD IP Dome Camera User Guide
3 Rotate 355°
4 Tilt 180°
"Dome Liner and Lower Dome Installation" section on
In-Ceiling Installation
2-3