Breville BPR600XL Instruction Book page 64

TROUBLESHOOTING
PROBLEM
EO is displayed on
LED Screen
E1 is displayed on
LED Screen
E2 is displayed on
LED Screen
E3 is displayed on
LED Screen, Beeping
The appliance automatically
switches to Keep Warm
without going through a
complete cooking cycle
Air is escaping from the rim
of the lid
Steam is released from the
pressure indicator valve
during cooking
EASY SOLUTION
a. Check that lid is closed properly.
b. Check that the Pressure Release Valve is in the
correct position.
c. Make sure the silicone rubber sealing gasket is in
good condition and attached properly to the gasket
holder (the arrows on the gasket should be facing
towards the lid).
• Unplug unit and allow to sit for 20 minutes. If no
change, Please call Breville Consumer Service.
• Ensure the cooking bowl is properly positioned
inside base. The cooking bowl must be in direct
contact with the heating plate. Make sure there are
no unwanted materials on the heating plate.
• SAUTE/SEAR setting will not work if the lid is on or
locked in position. Ensure the lid is off or placed on
top of the appliance in an offset position.
• Add more water to cooking bowl and restart the
cooking cycle.
a. Make sure the silicone rubber sealing gasket is in
good condition and attached properly to the gasket
holder (the arrows on the gasket should be facing
towards the lid).
b. Check that lid is closed properly.
a. Inspect the Pressure Indicator Valve/Rod (see page
9, letter "U"). The rod should move up and down
freely, and have a silicone seal on one end. Clean the
rod and replace the seal if necessary.
b. Make sure the silicone rubber sealing gasket is in
good condition and attached properly to the gasket
holder (the arrows on the gasket should be facing
towards the lid).
63