Back Panel Connections - GE DSR-2000e User Manual

1.8

Back Panel Connections

1. Ethernet Port: For viewing Live or Recorded images on a PC via the Ethernet.
2. Power Connector: Connect 12 Volt DC external power supply.
3. I/O Port: For connecting peripheral devices such as alarm devices, alarm relays, or the VEXT
connection.
4. SCSI Port: For connecting an SCSI compatible archive device.
5. RS-232 Serial Port: Serial port for Flash Upgrading of software. Also for external control of
unit.
6. Audio In: RCA jack, 315mV, 40k Ohms. Unbalanced.
Audio Out: RCA jack, 315mV, 600 Ohms. Unbalanced.
7. SVHS In: Y/C video input with 4-pin mini-DIN style connector.
SVHS Out: Y/C video output with 4-pin mini-DIN style connector.
8. Video In: Composite video input with BNC style connector.
Video Out: Composite video output with BNC style connector.
Caution: Do not connect both video inputs at the same time.
Ethernet Port
The cable connection configuration depends on your
network configuration:
•
For a DSR that connects directly to a Hub, use a
Straight Through connection.
•
For a DSR that connects directly to a PC, use a
Cross Over connection.
Consult with your MIS personnel for the specific type
of configuration. See section 5.5 Advanced Menu →
Communications for information about configuring
the ethernet settings in the menu system.
Figure 1-4 Back Panel
1 ALARM IN
2 ALARM OUT
3 RECORD START IN
4 ALARM RECORD
RESET
5 VEXT PULSE OUT
6 ERROR OUT
7 GROUND
8 VIDEOLOSS OUT
9 DISK END OUT
3 I/O
12V DC
ETHERNET
10/100
1 2
Wire Type: Cat 5
Connector Type: RJ-45
Max Cable Length: 100 feet / 30.5 meters
Minimum Cable Length: 6 feet / 1.8 meters
Hub Wiring Configuration: Straight Through
PC Wiring Configuration: Cross Over
5
AUDIO
SVHS
RS-232
IN IN
SCSI
OUT OUT
4 6 7
VIDEO
COMP
IN
OUT
8