Table of Contents
Advertisement
Disk End Out
The Disk End Out is activated when there is 5 minutes of
recording space left on the hard disk. It will also be activated if a
DAT or AIT tape archiving device is connected, and the tape
end is encountered. The DSR must be in Record mode, with
Background Archiving ON, and set to Continuous Overwrite
mode.
1.10
Setting the Time and Date
It is recommended that, as a minimum, the following menu items be configured before using the unit.
For detailed information about using the menu system, see section 3.
Main Menu → Time/Date → Set Time Format
o
To set the Time format, use the Jog to select the desired Time format.
Format the time as either:
•
12 HOUR
•
24 HOUR
Press the Enter button to confirm the selection and exit the menu.
Press the Menu button to exit the menu without making changes.
Main Menu → Time/Date → Set Date Format
o
To set the Date format, use the Jog to select the desired Date format.
Format the Date as either:
•
DD/MM/YY
•
MM/DD/YY
•
YY/MM/DD
Press the Enter button to confirm the selection and exit the menu.
Press the Menu button to exit the menu without making changes.
Main Menu → Time/Date → Set Time
o
To set the Time:
1. With HH MM SS highlighted, press the Enter button. The
highlighting will move to the row of numbers.
2. Enter the time in Hours, Minutes, and Seconds. Use the Jog to
change the values. Use the Shuttle to navigate among the
three fields.
3. Press the Enter button to confirm the selection.
4. To Save the changes and Exit the menu: Use the Jog to
select [OK], then press the Enter button.
5. To Exit the menu without making changes: Use the Jog to
select [CANCEL], then press the Enter button.
--OR—
--OR—
--OR--
Output: Open Collector
High: Transistor Off
Low: Transistor On
Active When On.
Current Out: 10mA Max
Minimum Duration: 0.5 Seconds
Time Format Setup
Select Format
12 Hour
Date Format Setup
Select Format
MM/DD/YY
Time Setup
HH MM SS
03 05 53
[CANCEL]
[OK]
Advertisement
Table of Contents
