Example Configuration - Cisco Catalyst 2950 Software Configuration Manual

Assigning Switch Information
The switch broadcasts TFTP server requests if the TFTP server is not obtained from the DHCP replies,
Note
if all attempts to read the configuration file through unicast transmissions fail, or if the TFTP server
name cannot be resolved to an IP address.

Example Configuration

Figure 4-3
Figure 4-3
Cisco router
Table 4-2
Catalyst 2950 Desktop Switch Software Configuration Guide
4-8
If the switch cannot read the network-confg, cisconet.cfg, or the hostname file, it reads the
router-confg file. If the switch cannot read the router-confg file, it reads the ciscortr.cfg file.
shows a sample network for retrieving IP information by using DHCP-based autoconfiguration.
DHCP-Based Autoconfiguration Network Example
Switch 1
00e0.9f1e.2001
10.0.0.10
DHCP server
shows the configuration of the reserved leases on the DHCP server.
Chapter 4
Switch 2 Switch 3
00e0.9f1e.2002 00e0.9f1e.2003
10.0.0.1 10.0.0.2
DNS server
Assigning the Switch IP Address and Default Gateway
Switch 4
00e0.9f1e.2004
10.0.0.3
TFTP server
(maritsu)
78-11380-04