Displaying Span Status - Cisco Catalyst 2950 Software Configuration Manual

Configuring SPAN
This example shows how to remove port 1 as a SPAN source for SPAN session 1 and to verify the
configuration:
Switch(config)# no monitor session 1 source interface gigabitethernet0/1
Switch(config)# end
Switch# show monitor session 1
Session 1
---------
Source Ports:
Destination Ports:Gi0/2
This example shows how to disable received traffic monitoring on port 1, which was configured for
bidirectional monitoring:
Switch(config)# no monitor session 1 source interface gigabitethernet0/1 rx
The monitoring of traffic received on port 1 is disabled, but traffic sent from this port continues to be
monitored.

Displaying SPAN Status

To display the status of the SPAN configuration, use the show monitor privileged EXEC command.
This is an example of output for the show monitor privileged EXEC command for session 1:
Switch# show monitor session 1
Session 2
---------
Source Ports:
Destination Ports:Gi0/2
Catalyst 2950 Desktop Switch Software Configuration Guide
20-8
RX Only: None
TX Only: None
Both: None
RX Only: Gi0/1
TX Only: None
Both: None
Chapter 20 Configuring SPAN
78-11380-04