Using The Interface Command - Cisco Catalyst 2950 Software Configuration Manual

Using the Interface Command

Figure 9-1
Using the Interface Command
The Catalyst 2950 switch supports these interface types:
•
•
•
You can also configure a range of interfaces (see the
page
Catalyst 2950 Desktop Switch Software Configuration Guide
9-4
Connecting VLANs with Layer 2 Switches
Host A
VLAN 20
Physical ports—switch ports
VLANs—Interfaces
Port-channels—EtherChannel of interfaces
9-7).
Chapter 9
Cisco router
Switch
Host B
VLAN 30
"Configuring a Range of Interfaces" section on
Configuring Interface Characteristics
78-11380-04