Configuring Snmp; Default Snmp Configuration - Cisco Catalyst 2950 Software Configuration Manual

Configuring SNMP

Figure 22-1 SNMP Network
SNMP Manager
For information on supported MIBs and how to access them, refer to
Configuring SNMP
This section describes how to configure SNMP on your switch. It contains this configuration
information:
•
•
•
•
•
•

Default SNMP Configuration

Table 22-2
Table 22-2 Default SNMP Configuration
Feature
SNMP agent
SNMP community strings
SNMP trap receiver
SNMP traps
Catalyst 2950 Desktop Switch Software Configuration Guide
22-4
Get-request, Get-next-request,
NMS
Get-bulk, Set-request
Get-response, traps
Default SNMP Configuration, page 22-4
Configuring Community Strings, page 22-5
Configuring Trap Managers and Enabling Traps, page 22-7
Setting the Agent Contact and Location Information, page 22-9
Limiting TFTP Servers Used Through SNMP, page 22-9
SNMP Examples, page 22-10
shows the default SNMP configuration.
Network device
MIB
SNMP Agent
Appendix A, "Supported MIBs."
Default Setting
Enabled
Read-Only: Public
Read-Write: Private
Read-Write-all: Secret
None configured
None enabled
Chapter 22 Configuring SNMP
78-11380-04