Resetting The 802.1X Configuration To The Default Values; Displaying 802.1X Statistics And Status - Cisco Catalyst 2950 Software Configuration Manual

Displaying 802.1X Statistics and Status

Command
Step 4
end
Step 5
show dot1x interface interface-id
Step 6 copy running-config startup-config
To disable multiple hosts on the port, use the no dot1x multiple-hosts interface configuration command.
This example shows how to enable 802.1X on Fast Ethernet interface 0/1 and to allow multiple hosts:
Switch(config)# interface fastethernet0/1
Switch(config-if)# dot1x port-control auto
Switch(config-if)# dot1x multiple-hosts

Resetting the 802.1X Configuration to the Default Values

You can reset the 802.1X configuration to the default values with a single command.
Beginning in privileged EXEC mode, follow these steps to reset the 802.1X configuration to the default
values:
Command
Step 1
configure terminal
Step 2 dot1x default
Step 3 end
Step 4
show dot1x
Step 5
copy running-config startup-config
Displaying 802.1X Statistics and Status
To display 802.1X statistics for all interfaces, use the show dot1x statistics privileged EXEC command.
To display 802.1X statistics for a specific interface, use the show dot1x statistics interface interface-id
privileged EXEC command.
To display the 802.1X administrative and operational status for the switch, use the show dot1x privileged
EXEC command. To display the 802.1X administrative and operational status for a specific interface,
use the show dot1x interface interface-id privileged EXEC command.
For detailed information about the fields in these displays, refer to the Catalyst 2950 Desktop Switch
Command Reference for this release.
Catalyst 2950 Desktop Switch Software Configuration Guide
8-14
Purpose
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Reset the configurable 802.1X parameters to the default values.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Chapter 8 Configuring 802.1X Port-Based Authentication
78-11380-04