Makita UM164D Instruction Manual page 9

towards the tool from the front.
To remove the blade cover, take the above installation
procedure in reverse.
Installing or removing base frame
CAUTION:
Before installing or removing base frame, be sure
•
to install the blade cover.
When installing or removing base frame, take care
•
that your fingers are not be pinched between the
tool and base frame.
1
010872
To remove the base frame, upset the tool and take it out
of the groove grabbing its bottom.
2
3
010873
To install the base frame, fit the protrusion of base frame
near the change lever into the hole for the sheared grass
height setting. With the base frame so fitted, pull the
lower part of base frame and fit the other part of the base
frame in the groove in the tool.
Installing or removing grass shear blades
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before installing or
removing shear blades. Failure to switch off and
remove the battery cartridge from the tool may
result in serious injury from accidental start-up.
When replacing the shear blade, always wear
•
gloves without removing blade cover so that hands
and face does not directly contact the blade. Failure
to do so may cause personal injury.
NOTE:
Do not wipe off grease from the gear and crank.
•
Failure to do so may cause damage to the tool.
1. Groove
2
2. Base frame
1. Change lever
1
2. Protrusion on
base frame
3. Base frame
For specific way of removing and installing shear
•
blades refer to the reverse of a package for
accessory shear blades.
010887
Remove the base frame and place the tool upside down.
CAUTION:
Before placing the tool upside down, be sure to
•
remove the base frame.
1
4
010888
To remove the shear blade, press the locking lever and
with the locking lever pressed turn the undercover
counterclockwise until the symbol
is aligned with the symbol
010889
Take out the undercover, shear blade and crank in order
from the tool.
9
1. Blade cover
1
1. Undercover
2
2. Locking lever
3
3. Press
4. Turn
on the undercover
on the locking lever.
1. Undercover
2. Shear blade
3. Crank
1
2
3