Makita UM164D Instruction Manual page 8

The lamp blinks in red
The lamp lights up in
red. (Note 1)
The lamp lights up in red.
(Note 1)
Note 1: The time at which the indication lamp lights up varies by the temperature
010970
Adjusting the shearing height
2
010871
Changing the position of holding the change lever allows
three-stepped setting for sheared grass height (10 mm,
15 mm, 25 mm).
To change setting, tilt the change lever for the base frame
position and with the change lever tilted move it up or
down along the tool surface until the protrusion on base
frame fits in one of the holes in the tool and release it.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Indication lamp
around the work area and the battery cartridge conditions.
1. Change lever
1
2. Protrusion on
base frame
3. Base frame
3
Status
This indicates the
appropriate time to
replace the battery
cartridge when the
battery power
becomes low.
This function works
when the battery
power is almost used
up. At this time, tool
stops immediately
Autostop due to
overload
Installing or removing blade cover
CAUTION:
Be careful not to contact the shear blade when
•
installing or removing the blade cover. Contacting
the shear blade may cause personal injuries.
1
010869
010870
Slide the blade cover from the tool's side until the shear
blade completely hides itself and then push in it lightly
8
Action to be taken
Recharge the battery
cartridge as soon as
possible
Recharge the battery
cartridge.
Turn off the tool.
1. Shear blades
2. Base frame
3. Blade cover
2
3