Makita UM164D Instruction Manual page 13

Chip receiver for hedge trimming (for Hedge
•
Trimmer)
Installing or removing hedge shear blades
CAUTION:
Before installing or removing shear blades, always
•
be sure that the tool is switched off and the battery
cartridge is removed.
When replacing the shear blades, always wear
•
gloves without removing blade cover so that hands
and face do not directly contact the blade. Failure to
do so may cause personal injury.
NOTE:
Do not wipe off grease from the gear and crank.
•
Failure to do so may cause damage to the tool.
For specific way of removing and installing shear
•
blades refer to the reverse of a package for
accessory shear blades.
Installing the hedge shear blades
1
1. Crank
2. Undercover
3. Shear blades
010904
Prepare the crank, the undercover and new shear
blades.
1
1. Basic alignment line on the tool housing
2. Pins
010905
Adjust the three pin position so that these three pins are
aligned with the basic alignment line on the tool housing.
2
3
2
4
1. Crank
2. Apply grease.
3. Pins
4. Recesed part of crank
010906
Fit the crank with its recessed part facing downward onto
the pins. At this time, apply a small amount of grease to
the periphery of the crank using grease that the shear
blades as optional accessory are provided with or that
remains inside gear housing.
1. Oval holes that are overlapped
2. Hole in the base plate of shear blades
3. Base plate
010907
Overlap the oval hole in the upper blade with that in the
lower one. Move the shear blades so that the hole in the
base plate of shear blades are positioned in the center of
these overlapped oval holes.
010908
Take out the blade cover from the old shear blades and fit
it onto the new ones for easy handling during the
replacement of blades.
13
1
2
1. Blade cover
1
1
2
3
3