Table of Contents
Advertisement
ASSEMBLING yOUR BREvILLE PROdUCT
8.
When removing the discs - carefully
remove the disc by placing one hand
on each side of the smooth edge and by
lifting the disc above the attachment
spindle on the motor shaft.
When removing the processing blades -
carefully remove the Quad
blade or dough blade by grasping the
central plastic support and lifting above
the attachment spindle on the
motor shaft.
NOTE
Reassemble the food processor by
locking the bowl into position before
attaching blades, disc or lid.
NOTE
Care should be taken when removing
the food from the processing bowl
by ensuring the motor and Quad
processing blade, dough blade or
disc, have completely stopped before
disassembling. Ensure the OFF button
is pressed to switch the motor off,
the appliance is switched off at the
power outlet and it is unplugged,
before removing the lid from the bowl.
The processing bowl should then be
unlocked from the motor body, then
®
the Quad
processing blade, dough
or disc carefully removed before
attempting to remove the
processed food.
OvERLOAd PROTECTION SySTEM
The motor is protected from burning out by
an automatic, temperature operated, cut-out
switch. If the food processor is overloaded
or operated continuously for too long, the
motor may overheat. If this happens, the
®
processing
power on light will continue to illuminate
even though the safety cut-out switch will
prevent the food processor from operating.
To operate the food processor again, you
must switch off, unplug and allow to cool for
approximately 30 minutes. Once the motor
has fully cooled, it is ready for use again.
Some stiff mixtures, such as dough, may
cause the dough blade to rotate more slowly
than normal. In this unlikely event of an
excessive load, do not operate the appliance
continuously with excessive load for more
than 30 seconds.
If the blades or discs should jam while
processing, ensure the OFF button is
pressed to switch the motor off and the food
®
processor is switched off at the power outlet
and the power cord is unplugged. Remove
the processing lid and adjust any food
wedged between the blade and the bowl or
in the disc. Replace the lid and proceed as
normal. If this occurs again, the processing
bowl may be overloaded, so remove some of
the food and process in smaller batches.
NOTE
The food processor is designed so
the motor will not operate without
the processing bowl and lid correctly
locked into position. In the event that
the food processor starts without the
lid correctly locked into position,
immediately disconnect at the power
outlet and return to your local Breville
Service Centre for examination.
The food processor can process foods in a
variety of ways depending on which blade or
disc you choose.
13
Hide quick links:
Advertisement
Table of Contents
