Configuring An Alternate Tftp Server (Optional); Setting Up Cts Components - Cisco TelePresence System 3200 Use & Care Manual

Configuring an Alternate TFTP Server (Optional)

Step 6 From the Cisco IP telephone welcome page, press Next. The system reboots.
The system might reboot several times during the initial startup process.
Note
Open a browser on a computer that is connected to the network.
Step 7
In the URL field, type the IP address that you obtained in
Step 8
Cisco TelePresence System Administration.
If you need to obtain the IP address, complete the following steps:
Note
a.
Note
b.
c.
Log in to the system by entering the following information:
Step 9
Log in using the following:
Step 10
Configuring an Alternate TFTP Server (Optional)
If you need to use an alternative TFTP server, configure the parameters for the alternative TFTP server
and related Cisco IP phone parameters in Unified CM in the Cisco Unified Communications Manager
IP Phone Device page. For instructions to configure an alternate TFTP server, refer to the
the Cisco TelePresence
your software release.
If you are using the TFTP address that DHCP supplies for Cisco Unified Communications Manager, do
Note
not perform this step.

Setting Up CTS Components

To set up the CTS components:
Cisco TelePresence System 3200
10-4
On the IP phone, locate Manual at the bottom of the screen and press the Manual soft key.
If you cannot locate the Manual button, proceed to Step
Locate Info at the bottom of the screen and press the Info soft key.
Scroll down to the IP Address listing and copy the address.
Username: admin (case sensitive)
–
Password: cisco (case sensitive)
–
System" chapter of the
Step 4 and press Enter. The browser launches
b.
Cisco TelePresence System Administrator's Guide
Chapter 10 First-Time Setup
"Configuring
for
OL-14521-01