Honeywell bendis king KLN 94 Maintenance Manual page 56

BENDIX/KING
C. Press the NRST button on the unit. If the test is passed, the following message will
be displayed.
D. If the test fails, the following message will be displayed.
E. If no failure is indicated, check "OK" on the Final Data Sheet.
5.2.4.19 REAL TIME CLOCK TEST
A. Turn the unit OFF.
B. Set the TEST switch (S9) to the open position.
C. Turn the left knob of the unit to the ON position.
D. Press the ENT button four times.
E. Turn the right outer knob of the unit until the bottom left side of the page displays the
word SET.
F. Turn the right inner knob until the bottom left side of the page displays the word
SET2.
G. The page should now show the correct GMT time and date.
H. If no failure is indicated, check "OK" on the Final Data Sheet.
5.2.4.20 GPS RECEIVER SATELLITE ACQUISITION TEST
A. Connect the antenna cable to the antenna connector on the rear of the unit.
B. Turn the right outer knob of the unit until the bottom left side of the display shows
the AUX page.
C. Turn the right inner knob to display the following page.
Rev 0, Sept/2000
Config Module Test
TST 10
Config Module Test
TST 10
15599M00.JA
Passed
Failed
KLN 94
Page 5-17