The undersigned, Yasuhiko Kanzaki, authorized by Makita Corporation, 3-11-8 Sumiyoshi-Cho, Anjo, Aichi, 446-8502 Japan declares that this product (Serial No. : series production) manufactured by Makita Corporation in Japan is in compliance with the following standards or standard- ized documents, HD400, EN50144, EN55014, EN61000 in accordance with Council Directives, 73/23/EEC, 89/336/EEC and 98/37/EC.
Page 5
Symbols The following show the symbols used for the tool. Be sure that you understand their meaning before use. [ Read instruction manual. [ DOUBLE INSULATION...
Selecting action mode 4. In cold weather or when the tool has not been For HR1820 (Fig. 4 & 5) used for a long time, let the tool warm up for Rotation with hammering: several minutes by operating it under no load.
Remove the crank cap using operations. Install the bit, then attach the dust collec- a Makita lock nut wrench 35 (optional accessory). tor on the end by turning and applying pressure. Then Rest the tool on the table with the bit end pointing secure it by turning the metal retainer clockwise.