Maintenance - Makita DF010D Instruction Manual

There is a tremendous force exerted on the tool/bit
•
at the time of hole break through. Hold the tool
firmly and exert care when the bit begins to break
through the workpiece.
A stuck bit can be removed simply by setting the
•
reversing switch to reverse rotation in order to back
out. However, the tool may back out abruptly if you
do not hold it firmly.
Always secure small workpieces in a vise or similar
•
hold-down device.
If the tool is operated continuously until the battery
•
cartridge has discharged, allow the tool to rest for
15 minutes before proceeding with a fresh battery.
Using the tool as a hand screwdriver
008718
Switch off the tool.
Move the lock button to the locked position A.
Turn the tool.
NOTE:
Use the tool with a fastening torque less than 5 Nm
•
(50 kgf.cm).
This use is
•
screwdriving.
Do not use the tool for work requiring excessive
•
force, such as tightening bolt M6 or bolts greater
than M6 or removing rusted screws.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.
convenient for checking
ACCESSORIES
CAUTION:
These
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Drill bits
•
Screw bits
•
Socket bits
•
Bit piece
•
Various type of Makita genuine batteries and
•
chargers
Plastic carrying case
•
the
10
accessories or attachments
persons. Only use
are
accessory or