EC Declaration of Conformity Sound pressure level (L ) : 70 dB (A) or less Makita declares that the following Machine(s): Uncertainty (K) : 3 dB (A) Designation of Machine: The noise level under working may exceed 80 dB (A) In-line Cordless Driver Drill Model No./ Type: DF010D...
The technical file in accordance with 2006/42/EC is moving parts. Damaged or entangled cords available from: increase the risk of electric shock. Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use 31.12.2013 of a cord suitable for outdoor use reduces the risk of electric shock.
18. Do not use the power tool if the switch does 29. Follow instruction lubricating not turn it on and off. Any power tool that changing accessories. cannot be controlled with the switch is dangerous 30. Keep handles dry, clean and free from oil and and must be repaired.
ENC007-7 FUNCTIONAL DESCRIPTION IMPORTANT SAFETY INSTRUCTIONS CAUTION: Always be sure that the tool is switched off and the • FOR BATTERY CARTRIDGE battery cartridge is removed before adjusting or Before using battery cartridge, read all instructions checking function on the tool. and cautionary markings on (1) battery charger, (2) Installing or removing battery cartridge battery, and (3) product using battery.
Switch action Adjusting the fastening torque 1. Lock button 1. Graduation 2. Switch 2. Adjusting ring 3. Pointer 008711 008713 The fastening torque can be adjusted in 21 steps by CAUTION: turning the adjusting ring so that its graduations are Before inserting the battery cartridge into the tool, •...
Page 7
Guideline for clutch auto-stop Work range of clutch auto-stop Increments on adjusting Fastening torque ring for fastening torque High speed Low speed Approx. 0.3 N m (Approx. 3 Kgf-cm) Approx. 0.82 N m Clutch auto-stop works (Approx. 8.4 Kgf-cm) Approx. 1.35 N m (Approx.
Page 8
008715 To install these types of bits, follow A=17mm 1. Lamp the procedure (1). B=14mm (Note) Makita bits are these types. To install these types of bits, follow A=12mm the procedure (2). B=9mm (Note) Bit-piece is necessary for installing the bit.
bit according to the instructions above. Drilling operation OPERATION First, turn the adjusting ring so that the pointer points to marking. Then proceed as follows. The tool can be used in two ways; a straight type and a Drilling in wood pistol type which is selectable according to the When drilling in wood, the best results are obtained with conditions of workplace and screwdriving.
Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. Drill bits • Screw bits • Socket bits •...