Table of Contents
Advertisement
This function creates clearer modulation during playback for high picture quality.
l
This function cannot be set to ON/OFF with the MENU screen displayed.
l
If power is interrupted for more than 60 minutes (power failure, etc.), the setting will return to ON.
l
Zero-Back Function
The zero-back function makes the cassette fast forward (or rewind) to the previously set "O:OO.OO" point and
stop there.
ZERO BACK
0
The zero-back function does not operate during recording. The function works during the playback, stop, fast forward, rewind and
l
With this feature you can quickly locate a desired section of the tape. The DPSS feature makes use of VISS
(index) signals to search for a specified tape segment and begin playback automatically.
Signal
( I n d e x )
An VISS (index) signal is automatically recorded on the
tape at the start of ordinary recording, simple recording
timer and timer recording.
a DPSS a
(VC-H690X)
a DPSS is3
0
0
0
(VC-H670X)
DPSS may not function properly if the VISS (index) signals are too close together (withln 5 minutes of each other).
l
DPSS can be cancelled by pressing PLAY/X2 or STOP.
l
If the tape reaches its end or IS rewound completely before locating the desired VISS (index) signal, DPSS is cancelled.
l
DPSS may not function for damaged or worn tapes.
l
The DPSS function cannot be used with tapes that contain no VISS (index) signals.
l
The starting point of a programme may vary slightly.
l
DPSS does not operate dunng the slow, record, timer standby, and timer recording modes, or when there is no cassette loaded
l
34
Press S. PICTURE on the VCR.
time the button is pressed, the mode switches between ON and OFF. (The New
Sharp Super Picture is preset to ON at the factory.)
ON:
Normally leave the mode set to ON. This high picture quality function will create a
clearer image during playback.
OFF:
Set to OFF when playing back a tape on the VCR while editing or when strong noise
appears on the screen. Set to OFF when using the VCR as an editing source.
the point you wish to return to later. "O:OO.OO" is displayed.
direction of the "O:OO.OO" position and fast forwards (or rewinds) the tape.
on the remote control.
Search starts immediately. (When a signal is located, the displayed number
decreases.)
begins automatically.
Advertisement
Table of Contents
