New Sharp Super Picture; Dpss (Digital Programme Search System) - Sharp VC-A210X Operation Manual

ml New Sharp Super Picture
This function creates clearer modulation during playback for high picture
8-_I]
quality.
S-PICTURE ON
I
Press the S. PICTURE button on the VCR.
I
"S.PICTURE ON (or OFF)" will appear on the TV screen for a few seconds.
Each time the button is pressed, the mode switches between ON and OFF.
(The New Sharp Super Picture is preset to ON at the factory.)
. . . . . . . .
SE-'
I
*:::::::::D
.
(PlCTURE]
NoTE
Set to OFF when playing back a tape on
strong noise appears on the screen. Set to
editing
source.
l
I t~s tunctlon only operates during playback. It will not operate when recording or watching a TV programme with the VCR tuner
l
This function can not be set to ON/OFF with the MENU screen displayed.
8 If power is interrupted for more than 60
seconds
(power failure, etc.), the setting will return to ON.
ON:
Normally leave the mode set to ON. This high picture quality function
will
create a clearer image during playback.
OFF:
the VCR
while editing or when
OFF when using the VCR as an
,N
Zero-Back Function
The zero-back function makes the cassette fast forward (or rewind) to the previously set "O:OO.OO" point and stop there.
the counter is displayed. then press the CLEAR button on
control at the point you wish to return to later. "O:OO.OO" is
ZERO BACK button on the remote control. The VCR 0 Press the
automatically detects the direction of the "O:OO.OO" position and fast
forwards (or rewinds) the tape.
@ When the tape reaches the "O:OO.OO" position, the tape automatically stops.
l
The zero-back function does not operate during recording. The function works during the playback
video search modes.
DPSS (Digital Programme Search System)
With this feature you can quickly locate a desired section of the tape. The DPSS feature makes use of
VISS (index) signals to search for a specified tape segment and begin playback automatically.
stop. fasr forward. rewind ancl
VISS (Index) Signal
An VISS (index) signal is automatically recorded
on the tape at the start of ordinary recording,
simple recording timer and timer recording.
t
,
I
t
V
t
t VISS (Index signals)
1,
SLOW- @-
o EPS&
8
@
0
Load a tape containing VISS (index) signals into the VCR.
Select the VISS (index) number of the desired programme using the
DPSS 8 or a button on the remote control.
Search starts immediately. (When a signal is located, the displayed
number decreases.)
When the selected
VISS (index) signal-encoded section is found.
playback begins automatically.
l
DPSS may not function properly if the VISS (index) signals are too close together (within 3 minutes of each other).
l
DPSS can be cancelled by pressing the PLAY/x2 or STOP button.
l
If the tape reaches its end or is rewound completely before locating the desired VISS (index) signal. DPSS is cancelled.
l
DPSS may not function for damaged or worn tapes.
l
The DPSS function cannot be used with tapes that contain no VISS (index) signals.
l
The starting point of a programme may vary slightly.
l
DPSS does not operate during the slow, record, timer standby, and timer recording modes, or when there is no cassette loaded,
23