Table of Contents
Advertisement
Simple Recording Timer
There are two ways to use this Simple Recording Timer for
your convenience.
Immediate Recording
. REC
Press
to terminate recording
STOP
l
Delayed Recording
. REC
0
( vcRi )
*After
the Simple Recording Timer is set, the channel position cannot be changed
ending time. And turn to the POWER STANDBY mode.
To clear the Simple Recording Tamer setting during setting of "Delayed Recording", press
l
clear after settrng, turn on the power, press
time is flashrng, press
CLEAR.
The Simple Recording Timer cannot be set If the trmer has been preset ("m'" indicator on the VCR display is lit). If this is the
l
case, cancel the timer standby mode by pressing
Simple Recording Timer.
Select the SP (Standard Play) or LP (Long Play) recording speed with
l
light up on the VCR display). SP (Standard Play) gives the best picture quality. LP (Long Play) gives the largest recording
time.
The stop time for delayed recording must be set within 10 seconds of setting the start time, otherwise start time must be set
l
again.
Immediate recordrng:
l
Convenient when havrng an unexpected visitor or
telephone call
Delaved
l
CHANNEL A/V (CH A/7).
(fx.: Channel position: 2)
@ Press REC to enter the normal recording mode. Then,
press REC repeatedly to set the desired ending time.
(fx.: Ending time: 9:30 AM)
Each press of
increases the stop time by IO minutes
REC
l
CHANNEL A/V (CH A/V).
(fx. : Channel position: 2)
time: 8:40 AM)
Each press of
Increases the start time by 10 minutes.
l
*Setting the time within a 24.hour period in IO-mrnute intervals is
possible.
Each press of
increases the stop time by 10 minutes.
REC
l
STANDBY to turn to the POWER STANDBY mode.
Press
(See page 5, item 2.)
(Ex.: Present time: 8:28 AM)
to select Simple Recording Timer mode, and then while the aSTART
turn on the power and then proceed with setting of the
TIMER ON/OFF,
TAPE SPEED
CLEAR
on the remote control. T
on the remote control ("SP" or "LP" will
O
25
Advertisement
Table of Contents
