Adjusting The Video Channel - Sharp VC-H670X Operation Manual

Adjusting the Video Channel

To view the output of your VCR on the television screen, you must select an unused channel on your TV and
tune it to the output of your VCR (factory preset to UHF channel 37).
(See page 5, item 3.)
Otherwise press PLAY/x 2.
channel must be selected each time the VCR is used.)
If picture interference appears on the TV screen in step 0 above, you can change the video channel (RF
l
output channel from the VCR) with the following procedure. (If UHF channel 37 is an active broadcast channel in
your area, manually select a different channel (UHF 28 to UHF 69) (see below) and then retune your TV as
above.)
(A) Press STANDBY (LOW POWER) on the VCR, or VCR STANDBY (for VCH690X) or STANDBY (for VC-
(B) Keep pressing MENU for more than two seconds to light up the : ii-13,,11:0r I I, r on the VCR display. ("VCR" is
displayed above c H-$'<RF.)
(C) Press CH~/CHA dn'the VCR or A/v button of a'-
channel for use as the video channel, then press SET.
(D) Repeat steps @ to @ above using the newly selected video channel.
10
I
on the remote control to manually select an unused