Tape Remaining Display - Sharp VC-H670X Operation Manual

Tape Remaioing Display
The tape remaining display only works with tapes recorded in PAL. It does not work with tapes recorded in
NTSC.
On Screen Display
* S e l e c t F U L L o r
C O U N T E R d i s p l a y
m o d e b y p r e s s i n g
MODE OSD on the
remote control.
l
the tape remaining for tapes recorded in NTSC or MESECAM modes.)
When you insert the tape and the VCR is in the stop mode, the tape remaining cannot be computed. The following Indicator
l
is shown when the tape remaining has not yet been computed or cannot be computed.
When you start recording or playback, the VCR will begin the computation. However, this may take some time.
l
When computation is completed, tape remaining will be shown on the OSD and VCR display for 5 seconds.
If the "REM." mode is selected with
l
forward or rewind for a few seconds and then the VCR will begin computing the amount of tape remaining.
During computation, will not function, and pressing
REC
l
Setting the DPSS or ZERO-BACK function during computation may cancel it.
l
The indicated length of tape remaining is only an approximate guide.
l
This function may not properly work for video tapes other than E-60, E-90, E-180 and E-240.
l
The length of tape remaining during fast forward or rewind may be indicated as greater than it actually is
l
When m and CFii!?Jq tapes are used with a cassette adapter, the indication may not be correct.
l
Warning for the length of tape remaining
When the tape reaches the point where only about five minutes of recording time is left, the remaining length of
tape will be automatically displayed, as a warning.
No warning, however, will be shown during timer recording or Simple Recording Timer recording
l
3 8
VCR Display
*Press DISPLAY on
REM
or and the VCR is In stop mode, the tape WIII automatically fast
MODE OSD DISPLAY
STOP, PLAY/x2,
the remote control.
[VCR display]
or other buttons will interrupt the computation.