Exclude A Door Lock Device; Exclude A Honeywell Thermostat - Honeywell Tuxedo Touch Series Installation And Setup Manual

Exclude a Door Lock Device

To exclude a door lock module from the Z-Wave network, do the following:
ICON
1. At the Tuxedo Touch Keypad:
a) Press the Automation icon from the
"Home" screen and then press the
Z-Wave Setup icon to display the
"Z-Wave Device Management"
screen.
b) Highlight the device to exclude and
press the Z-Wave Exclude/Delete
icon.
2. At the door lock:
a) Press the Function Key to exclude
the device from the keypad.

Exclude a Honeywell Thermostat

To exclude a Honeywell Thermostat from the Z-Wave network, do the following:
ICON
1. At the Tuxedo Touch Keypad:
a) Press the Automation icon from the
"Home" screen and then press the
Z-Wave Setup icon to display the
"Z-Wave Device Management"
screen.
b) Highlight the thermostat and press
the Z-Wave Exclude/Delete icon.
2. At the thermostat:
a) Follow the instructions in the
thermostat Installation Guide under
"Installer setup" to "Remove a Z-
Wave Network Connection".
b) Once the exclusion process is
complete, press Done and the
thermostat is excluded.
Automation (cont'd)
ACTION
ACTION
31
NOTES
Z-Wave Exclude/Delete-clears the node from the
keypad and resets device to the default setting.
Notes:
• If the device is not excluded, refer to the " Z-
Wave Troubleshooting " section.
• When excluding the door lock, the user code
associated with the door lock will remain in the
system. If needed refer to the panel Installation
Instructions on how to exclude this user code.
• To remove a defective device, refer to the " Z-
Wave Troubleshooting " section.
NOTES
Note: Honeywell is not responsible for property
damages due to improper setting of the
thermostat modes.
Z-Wave Exclude/Delete -clears the node from
the keypad and resets device to the default
setting.
Notes:
• If the device is not excluded, refer to the " Z-
Wave Troubleshooting " section.
• To remove a defective device, refer to the " Z-
Wave Troubleshooting " section.