Exclude/Delete Z-Wave Devices; Exclude/Delete A Door Lock - Honeywell Tuxedo Touch Series User Manual

SCAN SECURITY

Exclude/Delete Z-Wave Devices

Exclude a Light, Switch or Outlet Module
To exclude a light, switch or outlet module from the Z-Wave network, do the following:
ICON
1. At the Tuxedo Touch Keypad:
a) Press the Automation icon from the
"Home" screen and then press Z-Wave
Setup icon to display the "Z-Wave
Device Management" screen.
b) Highlight the device to exclude and
press the Z-Wave Exclude/Delete icon.
2. At the device module:
a) Press the Function Key to exclude the
device from the keypad.

Exclude/Delete a Door Lock

To exclude a door lock module from the Z-Wave network, do the following:
ICON
1. From the "Home" screen, press the
Automation icon and the Z-Wave Setup icon.
The "Z-Wave Device Management" screen is
displayed.
2. Highlight the device to exclude and press
the Z-Wave Exclude/Delete icon.
3. On the door lock press the Function Key to
exclude the device from the keypad.
Automation (cont'd)
ACTION
ACTION
Z-Wave Exclude/Delete -clears the node from the keypad and resets device
to the default setting.
Notes:
NOTES
Z-Wave Exclude/Delete -clears the node from the keypad and resets device
to the default setting.
Note:
• If the device is not excluded, or to remove a defective device, refer to
the " Z-Wave Troubleshooting " section.
NOTES
• If the device is not excluded, or to remove a defective device, refer to
"Z-Wave Troubleshooting".
• When excluding the door lock, the user code associated with the door
lock will remain in the system. If needed refer to the panel Installation
Instructions on how to remove this user code.
37