Mounting - Honeywell Tuxedo Touch Series Installation And Setup Manual

Mounting

This keypad is for indoor use only and should be mounted at a comfortable viewing level. Avoid
mounting in areas of high condensation such as bathrooms or in locations where bright light or
sunlight shines directly on the screen.
The keypad can be mounted with or without the mounting plate. Use the center securing screw for
European installations.
Mounting with mounting plate:
1. Select a mounting location.
2. Detach the mounting plate by sliding
downward.
3. Use the mounting plate to mark the location of
the mounting holes on the mounting surface
and check for level.
4. Locate the mounting plate over the mounting
surface such that the wire/cable access
openings are aligned while passing the
wires/cable through the case back.
**Go to "Wiring"
(next page)
5. Secure the mounting plate to mounting surface
using 4 screws (supplied).
6. Slide keypad onto mounting plate.
MOUNTING
SCREWS (4)
Mounting (European Installations)
using a center securing screw:
1. Detach case front by removing the two bottom
screws. Gently pull up using a screwdriver if
necessary and pry apart. Lift off cover.
2. Mount the keypad in its final location, (see
"Standard Mounting" or "Mounting without the
mounting plate") install center securing screw
(supplied) and tighten to mounting surface.
3. Replace the case front and secure using the two
bottom screws.
About the System (cont'd)
and complete wiring**
WALL
SURFACE
(TYP)
WALL
MOUNTING
PLATE
(OPTIONAL)
6280-006-V0
Mounting without mounting plate:
1. Select a mounting location.
2. Detach the mounting plate by sliding
downward and discard.
3. Use the template (provided in the carton) to
mark the location of the mounting screws and
the cut-out for the keypad assembly on the
mounting location. Check for level.
4. Install 4 screws (supplied) in the mounting
surface leaving screw heads 1/8" above the
mounting surface.
5. Locate the case back over the mounting surface
such that the opening is aligned with the
wire/cable access opening on the mounting
surface while passing the wires/cable through
the opening in the case back.
**Go to "Wiring"
(next page)
6. Mount keypad by sliding onto the screw heads.
6 2 8
0 S
E R
IE S TEMPLATE
C A
S E
B A
C K
M O
4 -
3/ 4" U N
T IN
G T
E M
P L
A T
E
CU T- O
UT
LO
CA TI O
N
DR
IL L
3/ 16
4 PL " DI
A. HO
AC ES LE
S
Ê 8
0 0 DR
80 0-0 - 0 IL L
88 31 0 8 3/ 16
3 1 MOUNTING
5/1 " DI
1 Re u Š A.
v.A HO
LE
SCREWS
INSTALLED
1/8" ABOVE
SURFACE
CASE
FRONT
CASE
BACK
DETACH CASE FRONT
BY REMOVING SCREWS (2)
AND LIFT UP
3
and complete wiring**
WALL
SURFACE
INSTALL CENTER
SECURING SCREW
6280-015-V0