Z-Wave Test - Honeywell Tuxedo Touch Series Installation And Setup Manual

Z-Wave Test

NOTE: This procedure is for Z-Wave test purposes only.
Role shifting is the process of shifting primary and secondary controllers. The secondary controller
becomes the primary controller with the ability to enroll Z-Wave devices. This is useful when the
primary controller is in a fixed location and the Z-wave device is not easily accessible (but within Z-
wave range). To perform the role shifting Z-Wave Test, do the following:
ICON
1. Press the Advanced Setup icon.
2. Enter your Authorized Code.
3. Press the Keypad Test icon.
4. With the status of the controller in the "P"
(Primary) state, press the Z-Wave Primary
Controller Shift to Secondary icon.
A pop-up window is displayed with the
following warning: "
controller shift function is for evaluation only
now. This primary controller is shifting to the
secondary. Please wait until the process
completes.
5. To shift the primary controller role to a
handheld controller, follow the handheld
controller manufacturer's instructions.
The pop-up message disappears and
controllers have shifted successfully. Z-
Wave devices can now be enrolled from this
controller.
Note: The Z-Wave Primary Controller Shift
to Secondary icon is inactive when the
Tuxedo Touch becomes the secondary
controller.
The Shift is completed when the warning
window disappears.
6. Shift the Tuxedo Touch back to the
primary controller after enrolling Z-wave
devices. First, initiate the role shift on the
handheld controller from primary to
secondary referring to manufacturer's
instructions. Then, press the Z-Wave
Secondary Controller Shift to Primary icon
on the keypad.
User System Setup (cont'd)
ACTION
Warning!! This Z-Wave
26
NOTES
Select from two main categories of tests:
• Z-Wave Role Shifting: Primary to Secondary
and Secondary to Primary.
• Z-Wave Basic Command: Set On or Off.
Note: The status of the controller can only be
changed from Primary to Secondary controller
when no devices are enrolled.
Use the delete device or reset controller function
to remove enrolled devices.