Ipv4 Pool Creation; Ipv6 Pool Creation - Cisco ASR 5000 Series Administration Manual

GGSN Service Configuration Procedures

IPv4 Pool Creation

Use the following example to create the IPv4 address pool:
Notes:
To ensure proper operation, IP pools should be configured within a destination context.
Each address in the pool requires approximately 24 bytes of memory. Therefore, in order to conserve available
memory, the number of pools may need to be limited depending on the number of addresses to be configured
and the number of PACs/PSCs installed.
Setting different priorities on individual pools can cause addresses in some pools to be used more frequently.
For more information on commands/keywords that configure additional parameters and options, refer ipv6 pool
command section in Context Configuration Mode Commands chapter of Command Line Interface Reference.

IPv6 Pool Creation

Use the following example to create the IPv6 address pool:
Notes:
To ensure proper operation, IP pools should be configured within a destination context.
Each address in the pool requires approximately 24 bytes of memory. Therefore, in order to conserve available
memory, the number of pools may need to be limited depending on the number of addresses to be configured
and the number of PACs/PSCs installed.
Setting different priorities on individual pools can cause addresses in some pools to be used more frequently.
For more information on commands/keywords that configure additional parameters and options, refer ipv6 pool
command section in Context Configuration Mode Commands chapter of Command Line Interface Reference.
OL-22944-02
Cisco ASR 5000 Series Gateway GPRS Support Node Administration Guide ▄
IP Address Pool Configuration on the System ▀