Authentication, Accounting, And Gtpp Group Configuration In Apn; Authentication And Accounting Configuration In Apn - Cisco ASR 5000 Series Administration Manual

▀ APN Configuration
Notes:
Up to 1000 APNs can be configured on a system.
APN templates should be created/configured within system authentication contexts or destination context.
Selection mode parameter‟s setting must be identical to the selection mode setting on the SGSN(s) that the
GGSN communicates with. The GGSN rejects attempts to establish PDP contexts from any SGSN having a
different setting.
If the APN supports Mobile IP for subscriber PDP contexts, then ip context-name command is used to indicate
the context in which the FA service is configured.

Authentication, Accounting, and GTPP Group Configuration in APN

This section describes the procedure to configure the authentication and accounting parameters for an APN. It also
specify the procedure to attach a GTPP group with an APN.
Step 1
Configure the authentication and accounting parameters by applying the example configuration in the Authentication
and Accounting Configuration in APN section.
Step 2
Attach a GTPP group with APN by applying the example configuration in the GTPP Group Association to APN section.

Authentication and Accounting Configuration in APN

Use the following example to configure the accounting mode and authentication parameter for APN:
Notes:
APNs are configured in system authentication contexts or destination context.
▄ Cisco ASR 5000 Series Gateway GPRS Support Node Administration Guide
If no context name is specified, the system uses the context in which the APN is configured.
If Mobile IP is supported and no name is specified, the system uses the context in which the GGSN
service facilitating the PDP context is located.
GGSN Service Configuration Procedures
OL-22944-02