Network-Requested Pdp Context Support Configuration; Ggsn Configuration Verification - Cisco ASR 5000 Series Administration Manual

▀ GGSN Service Configuration
Important:
policy is enabled to allow communication with unconfigured SGSNs. PLMN policies are configured using the

Network-requested PDP Context Support Configuration

Use the following example to configure the GGSN to support the network-requested PDP context:
Notes:
It is recommended that this functionality be configured in the system source context(s) along with the GGSN
service(s).
Up to 1000 IP address can be configured for network request PDP context support.
Only one GSN-MAP node can be configured per system context.

GGSN Configuration Verification

Step 1 Verify that your GGSN services were created and configured properly by entering the following command in Exec
Mode:
The output of this command given below is a concise listing of GGSN service parameter settings as shown in
the sample output displayed. In this example, a GGSN service called
observe some parameters configured as default.
▄ Cisco ASR 5000 Series Gateway GPRS Support Node Administration Guide
The GGSN only communicates with the SGSNs configured using this command unless a PLMN
command.
GGSN Service Configuration Procedures
was configured and you can
OL-22944-02