Charging Characteristics Parameter Configuration In Apn; Virtual Apn Configuration - Cisco ASR 5000 Series Administration Manual

▀ APN Configuration
If DHCP-Proxy and DHCP-Relay method is selected for IP address allocation, a DHCP service must be
configured on the system as described in DHCP Service Configuration section and specified the name of
DHCP Service by entering the
Commands chapter of Command Line Interface Reference.
If local pool is selected for IP address allocation, a local pool must be configured on the system as described in
IP Address Pool Configuration on the System section and specified the name of a private IP address pool by
entering the
Command Line Interface Reference.

Charging Characteristics Parameter Configuration in APN

Use the following example to configure the charging characteristics parameter for APN:
Important:
the GGSN Service Configuration section of this chapter for more information.
Notes:
If multiple behavior bits are configured for a single profile index, the variable bits is achieved by "Or"ing the bit
strings and converting the result to hexadecimal.
Example
If behavior bits 5 (0000 0001 0000) and 11 (0100 0000 0000) are both being assigned to profile index 5 for a home
subscriber, the appropriate command is

Virtual APN Configuration

Virtual APNs are references (or links) to alternative APNs to be used for PDP context processing based on properties of
the context. Use the following example to configure the virtual APNs.
▄ Cisco ASR 5000 Series Gateway GPRS Support Node Administration Guide
command as described in APN Configuration Mode Commands chapter of
Additional charging characteristics parameters are configurable as part of the GGSN service. Refer to
GGSN Service Configuration Procedures
command as described in APN Configuration Mode
.
OL-22944-02