Bluetooth Settings - Cisco 9971 Deployment Manual

Unified ip phone wireless lan deployment guide

Hide thumbs Also See for 9971:

Table of Contents

In the IPv4 Setup, select whether to use Dynamic Host Configuration Protocol (DHCP) or configure static IP

•

information.

If option 150 or 66 is not configured to provide the TFTP Server's IP address via the network's DHCP scope, then set

•

Alternate TFTP to Yes and enter the IP address for the TFTP Server.

Note: CCKM will be negotiated if enabled on the access point when using LEAP, EAP-FAST, or AKM.

If using 802.1x authentication via LEAP, EAP-FAST or AKM (authenticated key-management) authentication modes, then a

username and password must be configured. AKM mode will use LEAP as the 802.1x method.

WEP128 is listed as WEP104 on the Cisco Unified Wireless LAN Controllers.

For more information, refer to the Configuring Settings on the Cisco Unified IP Phone 9971 in the

Cisco Unified IP Phone 9971 Administration Guide at this URL:

http://www.cisco.com/en/US/products/ps10453/prod_maintenance_guides_list.html

Bluetooth Settings

The Cisco Unified IP Phone 9971 has Bluetooth 2.1 support, which enables hands-free communications.

Cisco Unified IP Phone 9971 Wireless LAN Deployment Guide

Table of Contents