Convert Rec-Path - Fujitsu Eternus DX100 S3 User Manual

Chapter 4 Copy Function Settings and Display
4.1 Advanced Copy Management > convert rec-path

convert rec-path

This command is used to convert the type of the REC path information file to the file type that is saved on and
to an FTP server by passing it through the ETERNUS DX. This conversion only affects the REC path information
file on the FTP server, and has no effect on the current system setup.
ETERNUS DX
Conversion
Logic
• If the same file on an FTP server already exists, it would be overwritten.
• If a TEXT type path information file has syntax errors, the number of the problem line is included with the
error message.
■ Syntax
convert rec-path -port {maintenance | remote | fst} -server
login_user_account
-user
-mode {t2b | b2t} [-indicator {enable | disable}]
■ Parameter
-port
-server
source_file
-source-file
This parameter specifies which Ethernet port is used to connect to the FTP server. For details,
refer to "1.11 Note for Specifying FTP Server" (page 35)
maintenance
MNT port
remote RMT port
fst FST port
Both a conversion source file and a conversion destination file must be in an FTP server. This
parameter specifies the FTP server name. The server name format is IPv4 standard notation (a
base 256 "d.d.d.d" string) or a fully qualified domain name.
Example: -server 192.168.1.20
Example: -server foo.bar
server_name
FTP server name
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
FTP server
Input file
TEXT
Output file
BINARY
server_name
output_file
-output-file
445
P2X0-1210-05ENZ0