Replacing Carbon Brushes - Makita 3708F Instruction Manual

1. Limit mark
1
2
1. Screwdriver
2. Brush holder cap
ACCESSORIES
14

Replacing carbon brushes

001145
Remove and check the carbon brushes regularly. Replace
when they wear down to the limit mark. Keep the carbon
brushes clean and free to slip in the holders. Both carbon
brushes should be replaced at the same time. Use only iden-
tical carbon brushes.
1
Use a screwdriver to remove the brush holder caps. Take out
001999
the worn carbon brushes, insert the new ones and secure
the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs, any
other maintenance or adjustment should be performed by
Makita Authorized or Factory Service Centers, always using
Makita replacement parts.
CAUTION:
• These accessories or attachments are recommended for
use with your Makita tool specified in this manual. The
use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding these
accessories, ask your local Makita service center.
• Straight & groove forming bits
• Edge forming bits
• Laminate trimming bits
• Straight guide assembly
• Trimmer guide assembly
• Trimmer base assembly (For chamfering with straight bit)
• Trimmer shoe
• Templet guide
• Collet cone 1/4"
• Wrench 10
• Wrench 17