Replacing Carbon Brushes - Makita DUH651 Instruction Manual

Replacing carbon brushes

► 1. Limit mark
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
1
► 1. Holder cap cover 2. Slotted screwdriver
Insert the top end of slotted screwdriver into the notch in
the tool and remove the holder cap cover by lifting it up.
1
► 1. Brush holder cap 2. Slotted screwdriver
Use a slotted screwdriver to remove the brush holder
caps. Take out the worn carbon brushes, insert the new
ones and secure the brush holder caps.
Reinstall the holder cap cover on the tool.
1
2
2
Storage
The hook hole in the bottom of the blade cover is con-
venient for hanging the tool from a nail or screw on the
wall.
Remove the battery cartridge and put the blade cover
on the shear blades so that the blades are not exposed.
Store the tool out of the reach of children carefully.
Store the tool in the place not exposed to water and
rain.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
12 ENGLISH